Hello everyone,
Can anyone tell me where I can get technical info / scematics for the ultimax 2 control on a KM3P Knee Mill. My machine boots up normally and the configuration is OK. When I go to the manual screen it displays X Y and Z machine positions as 2580mm on all 3. Max travel on the X is only about 600mm. If I then select calibrate machine it homes all axis normally but the machine position registers all seem to overflow and display only *******. I bought this mill non functional ,the pcb,s had been removed and the dip switch settings are probably wrong. There are 4 on the Memory board and 2 on the personality board.Can anyone please help with info on switch settings or offer advise regarding the position displays.
Many thanks in advance
Bertie