584,857 active members*
4,505 visitors online*
Register for free
Login
Results 1 to 2 of 2
  1. #1

    T32-3 no M commands after reinitialization

    Hello,

    I have this problem. After we lost parameters due to a faulty battery I did a reinitialization procedure for T32. I pulled parameters from the eeproms, Cleared all the areas to finally start the machine without any alarms, BUT I could not send home, SO I had to re-establish the home position with an instruction manual that I downloaded from the mitsubishi website. FINALLY, after numerous attempts the machine made it to the home position.

    NOW, MY PROBLEM NOW IS I can not get the chuck to open and close AND I can not turn the coolant ON and OFF in MDI mode. The chuck works fine in manual mode

    Any ideas?

    Thanks for the help

    jolulank
    www.doctornumerico.com
    cnc physicians

  2. #2
    Join Date
    Jan 2019
    Posts
    2

    Re: T32-3 no M commands after reinitialization

    Parameter R49

Similar Threads

  1. T32-2 reinitialization procedure parameter retrieve
    By jolulank in forum Mazak, Mitsubishi, Mazatrol
    Replies: 2
    Last Post: 06-26-2017, 04:52 PM
  2. T32-2 reinitialization procedure parameter retrieve
    By jolulank in forum Mazak, Mitsubishi, Mazatrol
    Replies: 0
    Last Post: 09-24-2013, 05:27 PM
  3. Who gives commands here?
    By Take-it-easy in forum CNC (Mill / Lathe) Control Software (NC)
    Replies: 1
    Last Post: 08-22-2011, 10:25 PM
  4. Dos Commands
    By LYN BYRD in forum Milltronics
    Replies: 12
    Last Post: 08-01-2011, 04:21 PM
  5. G2 and G3 Commands
    By Bohemund in forum G-Code Programing
    Replies: 19
    Last Post: 05-28-2007, 03:12 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •