hi
i know cnc mogul made a pretty bad product and have many complaints hence went out of business only after 1 yr but does anyone still have one of these crappy machines currently?
i have one that i got used and it runs like crap
the stepper motors are odd ..;if i run continuous mode and jog a
few feet you can see the axis going slower and faster..herky jerky
motion...
not sure if its bad driver board or what...even with machine not
connected you can see the stepper motors dont run smooth...they go
faster and slower..very odd...the z seems a bit smoother but the x and
y are horrible...i would say maybe a setting issue however a setting
should not cause the motor to run fast then slow during a step
move...the electronics are crap on this machine so that could be the
issue. or just worn out stepper motors..it does have a crappy
underpowered ps also so...lots of factors involved.
do anyone have the stepper motor settings for mach3
i doubt that has anyhting to do with the issue but good settings would be a good start.