Hello All
Hope you all out there are keeping well and safe.
I have many things on the go at this moment it time with my Micro CNC Mill, run with Mach 3. And tinker with small hand built electronic projects. I would like to bring these two together and cut out my own PCB tracks and hole layouts on copper clad boards. Can any recommend some simple free software to make up tracks and hole patterns then convert them to G Code to then port it over to the Mill to cut the holes and tracks. If possible the software has to run offline as the area in which my ManCave is located is in the dead zone as far as internet connection goes. Any suggestions will be most helpful.

Paul