Hallo all,
I have a strange problem with PlanetCNC TNG with Linux Debian (LinuxCNC runs on it fine).
My CNC has Mk3 board with lot of peripherlas and PlanetCNC TNG SW running under Win10 without any issues. Since I am also using LinuxCNC on the same NUC PC and each Win10 update brings some "unexpected" problems recently, I would like to switch to Linux permanently.
When I have installed PlanetCNC TNG under my Linux Debian it starts and all seems fine (profile was improted from Win machine to have exactly same seetings). SW detects Mk3, all seems fine, anyhow immediately after I issue e.g. "home" then it starts pop-up dialogs that it has no license. Without changing anything just restart back to Win10 it works without any issue so it is not cable or HW problem.

Any idea how could I solve it?
thx and regards, Vlado