[num1bryanp]

Hello Everyone,

I am in the process of adding a 4th axis to my BP 720. But I am having a hard time finding some of the connectors I need to finish the project. The pictures below will show the connectors I am looking for.

1. I need one 6 pin male and one 3 pin male connectors to connect to the ones shown with yellow around them
DCBA Distribution board


2. Need one 6 pin female connector to connect to the one shown.
Fanuc AC servo driver A06B-6050-H102, top board power connector.
Inside connector dimensions 1.38 x .30

3. Need one female 9 pin Heidenhain flange connector like one in picture

Thanks,
Bryan

[machinehop5]

...try Molex search comes to mind.
https://www.digikey.com/products/en?keywords=molex

[dazp1976]

Hello Everyone,

I am in the process of adding a 4th axis to my BP 720. But I am having a hard time finding some of the connectors I need to finish the project. The pictures below will show the connectors I am looking for.

1. I need one 6 pin male and one 3 pin male connectors to connect to the ones shown with yellow around them
DCBA Distribution board


2. Need one 6 pin female connector to connect to the one shown.
Fanuc AC servo driver A06B-6050-H102, top board power connector.
Inside connector dimensions 1.38 x .30

3. Need one female 9 pin Heidenhain flange connector like one in picture

Thanks,
Bryan

What about IDC?
https://www.amazon.co.uk/s?k=idc+2.5...ref=nb_sb_noss
Just for example.

[zurferjoe]

Hello Everyone,

I am in the process of adding a 4th axis to my BP 720. But I am having a hard time finding some of the connectors I need to finish the project. The pictures below will show the connectors I am looking for.

1. I need one 6 pin male and one 3 pin male connectors to connect to the ones shown with yellow around them
DCBA Distribution board


2. Need one 6 pin female connector to connect to the one shown.
Fanuc AC servo driver A06B-6050-H102, top board power connector.
Inside connector dimensions 1.38 x .30

3. Need one female 9 pin Heidenhain flange connector like one in picture

Thanks,
Bryan

Hi there , did you get the plug you needed ? Now I have a question , what is the parameter number for the 4th axis ? As I did not change my batteries in the controller and lost all the parameters ! Got them all back thanks to another forum memeber , but it did not have thge 4th axis number , hope you can help , all the best Harry