Hi, My Amada M6B punching machine , alarms with "Overide light" Has been tried many ways to reset it, but won't worked.
Any suggestion would be greatly appreciates.
PJ.
07/07/2020
Hi, My Amada M6B punching machine , alarms with "Overide light" Has been tried many ways to reset it, but won't worked.
Any suggestion would be greatly appreciates.
PJ.
07/07/2020
Hi,
In the middle of the X-axis carriage, the override detection system is assembled and it is related to the Y-axis position. So you have to check both the area. you have to check the input signal in diagnostic no 40.2 & 40.3 for left & right override, 42.7 for override X, 42.4 for override Y external slow down, and according to the electrical schematic you can find the solution.
Regards,
Deepak
Dear Deepak,
Thank you so much for your kind suggestion, will check it out and see what's up.
One thing , in diagnostic No, 036 parameter 4 (OVC Override cancel) I could not set it to 0.
Best regards,
PJ.