[Skipio1]

Hello all.
Is it possible to jog the motors in mach3 demo version. Thanks in advance.

[Jim Dawson]

I think so, you have to set the HotKeys as I recall.

[joeavaerage]

Hi,
if jogging is enabled it is certainly possible to jog....wouldn't be much of a CNC solution if it didn't.

Craig

[CitizenOfDreams]

I believe Mach3 demo jogs exactly the same as the licensed one. Just install the program, configure ports/pins and use the arrow keys for jogging. No hotkeys required.

Or did you mean something else like using a jog wheel controller?

[Skipio1]

I believe Mach3 demo jogs exactly the same as the licensed one. Just install the program, configure ports/pins and use the arrow keys for jogging. No hotkeys required.

Or did you mean something else like using a jog wheel controller?

Thanks for your reply, my problem is I bought a 3040T machine but received no instructions on setup. Found a YouTube video how to configure so did all it said but nothing moves. Running Mach 3 demo on windows 7 32 bit. ????????????????????????????

[CitizenOfDreams]

I bought a 3040T machine but received no instructions on setup. Found a YouTube video how to configure so did all it said but nothing moves. Running Mach 3 demo on windows 7 32 bit.

As I understand, "3040T machine" can mean pretty much anything in Aliexpress-speak, so the video you found is not necessarily relevant.
If it has a USB controller, make sure you have the correct Chinese USB driver for that particular controller. Ask the seller where to download one if it did not come with the machine.

[Skipio1]

As I understand, "3040T machine" can mean pretty much anything in Aliexpress-speak, so the video you found is not necessarily relevant.
If it has a USB controller, make sure you have the correct Chinese USB driver for that particular controller. Ask the seller where to download one if it did not come with the machine.

Thanks mate I’ll email them