[HamzaB]

Hello Sir, we have a Turret Punch Press Strippit 1250 MH machine which controller is GE Fanuc O-P Series . We have this problem that the controller is not booting.Please tell me solution.

[Deepak83]

Hi
if you can make a small video and send it to me, it is better to understand me and accordingly I can explain it to you.

Regards
Deepak

[HamzaB]

Hi
if you can make a small video and send it to me, it is better to understand me and accordingly I can explain it to you.

Regards
Deepak

video is not being uploaded to this forum.this is model of our machine Strippit Fc 1250mh,Controller GE Fanuc O-P Series.The control does not ON.The machine would turn off as soon as the power ON

[HamzaB]

Do you have any procedure to boot the controller?

[bill4807]

You may have a short somewhere. As the controller boots up and sends control power out to sensors and outputs, one shorted could draw down the power supply and shut the control back off. Seen it many times.