I was cutting a job yesterday. It had finished when the machine lost power. This morning when I turned it all on i have this problem. It tells me that "the reset logic of the software is active. Remove the reset condition ...... etc."
I cannot reset it. When I push the reset button the same error box pops up. All the limit switches seem to be operating correctly. This is what I have:
UCCNC v 1.2111 (I had 1.204 until this happened so I installed latest version to see if it would cure it)
UC300eth-5lpt
Using port 2
C10 BOB
In the diagnostic screen it shows pins 8 and 9 as red. Those pins are connected to Axis C. C is slaved to Y and I have a limit switch on Y- and C- so that they can sync. I have had this setup for years.
What I have tried.
1. I made a new profile using port 3. Same problem - now the red 8 and 9 show up on port 3
2. Disconnected the BOB from the UC - made no difference - still have the errors. (this tells me that it is not wiring ?????)
I'm going to try to upload some pictures
Any ideas??
Thanks