Hi all

Wonder if anyone has a good post processor for the Fadal88HS?

I've messed around with the clearance height and retract heights but after the initial tool change the second and following tools are not at a safe height when transiting across the workpiece. I feel it's a post processor issue but I'm not real familiar with modifiying them.

I usually like to have a safe Z of 2" but this will initially start the spindle well above the workpiece and turn flood on but on subsequent tool changes it seems like it drives the tool down to top of stock, starts spindle then transits at maybe .1" above....gets to say new hole location, retracts to clearance height goes down, then feeds to depth, retracts to just above workpiece height then transits across workpiece again, instead of going to clearance height.

Any suggestions would be appreciated!

g code attached