What we have is a,
Anilam 5000M-3X
Serial: 1129595216
D of M: 2005
PC Firmware version: 3.21A
DSP Firmware version: 2.50X-5
DOS version: 6.22
Problem encountered: At boot up memory check clears, finds bootable section on C: drive, Starts ROM DOS, Software option screen comes up, <Select> control software,
Abnormal Program Termination: Memory Protection Fault
CS:EIP= 000CH:00047C04h
C:\P5M> Divide By Zero
We have replaced, in steps, the CMOS battery, reconfigured BIOS, reinstalled the last machine configuration, changed the RAM with new, scanned the hard drive for errors and at each step we still get the same message every time. 5 and 12 volt power checks out good.
And on two occasions we have observed the following message after a reboot:
ROM DOS Fatal Error, Memory Corrupted
Any Ideas????? Thank you