585,705 active members*
3,899 visitors online*
Register for free
Login
IndustryArena Forum > MetalWorking Machines > HURCO > NO MOTION CONTROL BOARDS WERE DETECTED IN THE SYSTEM

Thread: NO MOTION CONTROL BOARDS WERE DETECTED IN THE SYSTEM

Results 1 to 3 of 3
  1. 07-17-2020, 07:14 AM #1
    fsebascg
    fsebascg is offline
    Join Date
    Jul 2020
    Posts
    1

    NO MOTION CONTROL BOARDS WERE DETECTED IN THE SYSTEM

    Hi!!

    Please I need help!!! recently I got a hurco vm1 2006 from USA, when I bought it, it was working. When it arrived to my country (Ecuador) the pandemic started so it was a long time turned off, recently I turned on and I charged the BIOS and I could start with the ultimax control v 2.36.01e/2.04.05i but the error "NO MOTION CONTROL BOARDS WERE DETECTED IN THE SYSTEM" appeared. I recieved help from an electrical technician and he told me the electronic of the machine is ok so I don't know which is the problem.
    I have some diskettes one of them has a software upgrade a the others are optikeys.

    Thanks very much for reading!!
    Best regards,
    Sebastian
    Reply With Quote Reply With Quote
  2. 07-20-2020, 06:20 PM #2
    cnc-exit
    cnc-exit is offline Member
    Join Date
    Apr 2019
    Posts
    58

    Re: NO MOTION CONTROL BOARDS WERE DETECTED IN THE SYSTEM

    Motion control are there please disconect wires. And then connect.

    It is posible power suply fail

    [email protected]
    +37060022992
    Reply With Quote Reply With Quote
  3. 12-12-2020, 07:13 PM #3
    sureyyasertasi
    sureyyasertasi is offline
    Join Date
    Dec 2020
    Posts
    2

    Re: NO MOTION CONTROL BOARDS WERE DETECTED IN THE SYSTEM

    i am having the same problem on my machine, i would be grateful if you could help
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Looking into motion control/breakout boards and after recommendations
    By willheg in forum LinuxCNC (formerly EMC2)
    Replies: 8
    Last Post: 10-07-2020, 10:39 AM
  2. Recommendations on motion control boards & Single Board Computer
    By mike944 in forum Controller & Computer Solutions
    Replies: 11
    Last Post: 12-12-2018, 09:57 PM
  3. Motion Control Board Selection, any USA made boards with support?
    By smcdonn in forum Mach Mill
    Replies: 8
    Last Post: 07-03-2018, 06:59 PM
  4. BoB & Motion Control Boards ?
    By coils in forum CNC Machine Related Electronics
    Replies: 6
    Last Post: 10-16-2014, 02:23 AM
  5. DynoMotion K-Flop vs MicroKinetics MN400 Motion Control Boards
    By beduion in forum Controller Cards
    Replies: 3
    Last Post: 07-27-2010, 08:47 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules