[bigodinos]

Hello everyone, often I leave the milling machine to work alone and go home. Is there a program that if the milling machine stops for any problem, or Simply program finish i am warned by a call or by a message? Work on selca 4000 cnc with windows xp. Thanks to all

[BBMNet]

Hello.

While it is possible to do as you want I think it might be better to use an IP camera so that you can alway take a look at what your machine is actually doing at any given time. There are a number of low priced units on the market.

Another posibility is to use a smart phone for the same purpose. There are a number of apps to do that. ALFRED is one.

Using the camera you can also check your premises as there are units that you can rotate and tilt.

I hope this helps.

Regards.

[bigodinos]

Hello.

While it is possible to do as you want I think it might be better to use an IP camera so that you can alway take a look at what your machine is actually doing at any given time. There are a number of low priced units on the market.

Another posibility is to use a smart phone for the same purpose. There are a number of apps to do that. ALFRED is one.

Using the camera you can also check your premises as there are units that you can rotate and tilt.

I hope this helps.

Regards.

Thanks, but i Need a software

[drdos]

Remote Light Stack interfaces directly with the existing real light stack with up to five (5) lights on the CNC machine. It turns those lights into e-mails or text messages that can remotely notify anyone with an e-mail address or SMS (texting) capable cell phone. It can also update a website in real-time reflecting the status of the lights. Unlike traditional auto-dialers and pagers, Remote Light Stack uses your network so it requires no additional phone line and can send multiple simultaneous notifications to different destinations instead of a single phone call or page.
REMOTE MACHINING
Ph/Fax 1-800-248-1817
e-mail: [email protected]