584,865 active members*
5,018 visitors online*
Register for free
Login
Results 1 to 3 of 3
  1. #1
    Join Date
    May 2009
    Posts
    32

    4th axis question

    I installed a Koma 4th on a mill with an Oi-F controller. The rotary will move and go to the commanded position just fine. The position page shows the position for the rotary. My problem is that in the work offset page the 4th axis is not visible. I can't set any offsets for the 4th axis. Any ideas?

  2. #2

    Re: 4th axis question

    I only see it being avaiable in the "T" control which is the lathe type.

  3. #3
    Join Date
    Jul 2017
    Posts
    50

    Re: 4th axis question

    Probably prm 3134

Similar Threads

  1. 4th axis question
    By saabaero in forum Tormach Personal CNC Mill
    Replies: 7
    Last Post: 09-04-2017, 11:55 AM
  2. Y-Axis / Z-Axis Bearing Setup Question
    By KittyPants in forum DIY CNC Router Table Machines
    Replies: 0
    Last Post: 08-22-2013, 10:45 AM
  3. Rookie Question...3 axis vs 4 axis controller
    By Ferrari2007 in forum DIY CNC Router Table Machines
    Replies: 3
    Last Post: 09-14-2009, 02:04 AM
  4. question about 4th. axis
    By 69ss396 in forum Haas Mills
    Replies: 2
    Last Post: 07-01-2009, 04:13 PM
  5. 5 axis question
    By turmite in forum Mechanical Calculations/Engineering Design
    Replies: 50
    Last Post: 11-06-2005, 11:34 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •