I have an OSP5020M with Dnc-B as baurate 4800, I want up to 9600 please help me ..... thanks
I have an OSP5020M with Dnc-B as baurate 4800, I want up to 9600 please help me ..... thanks
You should be able to change Parameter word #39 to 9600 if using channel 1. Be sure to wait for about 2.5 minutes for backup to occur automatically and the power down including the breaker for 1 minute to let the RS board reset properly.
Best regards,
Experience is what you get just after you needed it.
Then I would suspect that you are not using channel 1. Check your word#43 parameter to see what it is set to. I believe that is designating which port DNC will use. If 0 then using channel 0 and so forth. If 0 then try setting baud on word#6. Channels 2,3,4 are Word 40,41,42. Change the appropriate one as described before.
Best regards,
Experience is what you get just after you needed it.
Did you follow my exact instructions about powering down with breaker off for 1 minute?
If you did then go to the parameter mode on the machine and type in CMPS and tell me if some “magic” DNC parameters open up.