[berntd]

Hello,

I have created a dxf drawing as well as 3D model of a clock hand I would like to make from a piece of flat metal, which is already the correct thickness.

I am new to mastercam and have been struggling for several days to get through splines, chaining, extruding etc try and get it to do what I want - to no avail.

The only toolpath I managed to generate successfully was dynamic and it wants to remove heaps of stock and leave my hand as a boss on top of the stock block with everything around it removed.

That would take hours of machining with my slow little Sherline machine.

So I would like it to create a toolpath that will follow the outline of the clock hand drawing or model and repeat this operation until the correct depth / break through is reached.

What toolpath type do I need to for this and how would I set that up?

I will be using a 1/16" endmill and I have created that already.

The hand design is such that a 1/16" will be able to cut all the curves so no issues there.

Any help or advise, is greatly appreciated.

[Punk4520]

Just do a contour with depth of cuts set to the amount desired. If you want to send the file over, I will be glad to look at it.
[email protected]

[berntd]

Hello,

Thank you. I have emailed you the files. I have also attached the files here too.

My attempts of creating a 2D countour path have all failed.
In hand3, I tried to create a groove of the diameter of the endmill (1/16") but that also failed.

Best regards
Bernt

[Samacxanh]

You can use 2D toolpath' 'Mastercam: Contour and Pocket.
Or contact to me, help you: [email protected]
-----------------
Mastercam Training

[cadcam]

Did any one get you some sample paths for this? What version of Mastercam are you running?