I am running a 600 line engraving program on a Haas, need to run again at a different depth. Have been changing tool length comp, but loosing too much time.
I am running a 600 line engraving program on a Haas, need to run again at a different depth. Have been changing tool length comp, but loosing too much time.
Add G92 Z-10 (Or Z-Whatever you need)
It should shift the Z coordinates and run all the nc accordingly
Make sure however that all your rapid moves are still above material, or at least inside the pocket you already performed.
Thanks Lucas for taking time to help. Will try it today.