New to Multicam equipment, picked up an SF 4x8 table that had the original controller upgraded to the RPD-24 controller (pic attached) w/ pendant. I was exploring in MotionMechanic and inadvertently overwrote the firmware (dumbest thing I've done all week). I am in desperate need of a program file I can upload to it and checking on parameters. Right now it is dead in the water. Anyone out there that can assist? I'd rather pay someone on here a reasonable amount of $$ for help then have to contact Multicam. Thank you much!
Results 1 to 2 of 2
-
08-22-2020, 02:48 PM #1
Member
- Join Date
- Aug 2020
- Posts
- 8
Multicam SF Model w/ RPD-24 Controller, overwrote program
-
08-22-2020, 09:12 PM #2
Member
- Join Date
- Aug 2020
- Posts
- 8
Re: Multicam SF Model w/ RPD-24 Controller, overwrote program
Here is a pic of where I sent a standard G-code file to. I assume it overwrote the controller program? Maybe just the parameters? Never used MotionMechanic, any help would be greatly appreciated.
Reply With QuoteSimilar Threads
-
SF Model w/ Updated Pendant Style Controller, lost program
By jimmycissell in forum Multicam MachinesReplies: 3Last Post: 08-27-2020, 01:22 PM -
MultiCAM 1000 how to program oscillating knife cutter
By Hezz in forum Multicam MachinesReplies: 0Last Post: 03-27-2020, 04:16 AM -
Multicam plasma controller
By Riefaat in forum CNC Machining CentresReplies: 0Last Post: 02-13-2019, 07:01 PM -
Multicam SF (Older Model) Control Panel Re-design to Print
By BASiQ in forum Multicam MachinesReplies: 3Last Post: 03-11-2015, 01:26 AM -
Multicam Program Issues
By Stephen Samuels in forum Multicam MachinesReplies: 1Last Post: 03-10-2013, 04:54 PM
Tags for this Thread
Posting Permissions
