I have been working for a while with manual tool change but there is an issue with the heights and I don't know where it comes from, PP or internal script or settings.

Before I start a new job I probe the X,Y,Z Zeros at the Working position, then press start and the tool goes to the fixed sensor to measure the tool length. Everything works fine until the first tool goes to the feed height of the part, it always goes to the feed height of the last tool from the previous job.

Then I stop the job, probe again the Z of the part and start again the Job and everything works well including tools changes. (Again, until the next job).

I would be happy if anyone has a solution to the issue.

Thanks in advance,
Chen