584,841 active members*
4,272 visitors online*
Register for free
Login
IndustryArena Forum > MetalWorking Machines > Syil Products > Syil X3 CNC No movement from steppers or Spindle
Results 1 to 2 of 2

Threaded View

  1. #1

    Syil X3 CNC No movement from steppers or Spindle

    Hello,

    I just bought a Syil X3 CNC from an estate sale. It looked like it was used until it the owner passed away. I can get the computer on, mach3 loaded with the Syil X3 config, and jogging within mach3. I checked continuity between the DB25 connector, all good. When I power the X3 on I see a green light for the spindle. When I try to turn on (start, speed up, etc.) it just beeps. I press the estop and the spindle speed lcd goes out, and comes back when I reset the estop. When the spindle speed lcd turns on, it says 0080. I press start but it never turns on, and I cannot increase or decrease the speed.

    My other problem is with the steppers. When the power is on I can barely turn the ballscrews, so it seems the steppers are getting some power. I tool the back panel off and saw a red led on each of the stepper drivers. I have checked the estop operation and they seem to be functions ok on the switch side. I have attached some pictures. Does anyone have the datasheet for the Syil 2 phase stepper driver?

    Any thoughts?
    Attached Thumbnails Attached Thumbnails IMG_20200828_152446.jpg   IMG_20200828_152449.jpg   IMG_20200828_152455.jpg   IMG_20200828_163408.jpg  

    IMG_20200828_163412.jpg  

Similar Threads

  1. No movement from the steppers
    By neric in forum Stepper Motors / Drives
    Replies: 0
    Last Post: 07-20-2010, 12:59 PM
  2. Replies: 6
    Last Post: 05-13-2010, 12:52 PM
  3. Can Not get any movement from steppers.
    By millman52 in forum Machines running Mach Software
    Replies: 2
    Last Post: 06-01-2009, 12:23 PM
  4. Jerky Movement - Syil X3 Mach 3
    By Megaplow in forum CNC (Mill / Lathe) Control Software (NC)
    Replies: 1
    Last Post: 01-09-2008, 04:10 PM
  5. No Movement of steppers help please
    By rally.sport in forum Machines running Mach Software
    Replies: 2
    Last Post: 12-22-2006, 04:05 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •