Hello,
I want to generate toolpaths for a drag knife. And I don´t want to select every curve seperately. Is it possible to disable the auto join so madCAM creates a single toolpath for each curve? Like the right one in the picture?
Hello,
I want to generate toolpaths for a drag knife. And I don´t want to select every curve seperately. Is it possible to disable the auto join so madCAM creates a single toolpath for each curve? Like the right one in the picture?
Hello,
It should work if you set the Cut-Link distanse to zero. You can set the Cut-Link distance for each cutter tool in madCAM.
/Joakim