585,722 active members*
4,228 visitors online*
Register for free
Login
IndustryArena Forum > CNC Electronics > Leadshine > MX4660 with UC100 and UCCNC. Need help with output 1

Thread: MX4660 with UC100 and UCCNC. Need help with output 1

Results 1 to 2 of 2
  1. 10-24-2020, 08:26 PM #1
    ArtChenko1990
    ArtChenko1990 is offline
    Join Date
    Jul 2020
    Posts
    1

    MX4660 with UC100 and UCCNC. Need help with output 1

    Hello Everyone.

    I am building my first CNC Plasma table. I am using MX4660 with UC100 and UCCNC software.

    I am currently trying to wire in a 12v relay, I have it wired as follows.

    power supply 12V + to Relay coil +
    Relay coil - to MX4660 Output 1 +
    MX4660 Output 1 - to power supply 12V -

    (I have also tried wiring backwards.)

    In UCCNC I have configured spindle M3 Relay to PIN 17 PORT 1.

    According to everything I read when I press the torch "ON" button in UCCNC the 12v relay should trigger and close the loop between Pin 3 & 4 on the plasma cutter triggering the torch.

    However the 12V relay is not closing.

    What could I be doing wrong here?

    Am I missing anything?

    Thank you all in advance.
    Reply With Quote Reply With Quote
  2. 10-29-2020, 01:55 AM #2
    Leadshine
    Leadshine is offline Registered
    Join Date
    May 2015
    Posts
    38

    Re: MX4660 with UC100 and UCCNC. Need help with output 1

    Hello, this is Jason Peng from Leadshine, It seems I had replied your this problem by email,please check. thanks.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Motors don't run - Mach3- Leadshine MX4660 - UC100 USB
    By pilotarix in forum Mach Software (ArtSoft software)
    Replies: 5
    Last Post: 05-13-2022, 06:46 AM
  2. Windows, UC100 and UCCNC not happy with each other
    By kennected in forum UCCNC Control Software
    Replies: 8
    Last Post: 09-04-2018, 01:00 AM
  3. Leadshine MX4660, UC100 CNC motion controller, Mach3 and a touch probe = problem
    By pilotarix in forum Leadshine
    Replies: 8
    Last Post: 04-13-2018, 08:48 PM
  4. Bobcad V24 + Gecko 540 + UCCNC + UC100
    By jcarpenter2 in forum BobCad Post Processors
    Replies: 7
    Last Post: 01-13-2016, 09:27 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules