[pvougi]

Hi,
The batteries died in our Fanuc O-M control wiping out all the parameters. The machine is an excel 810 VMC 1993. Does anyone have a the same year,make and model machine that we could get the parameters from?
Need help ASAP!!!!

Thanks,
Pete

[Al_The_Man]

Oh..O There a lesson there for all those that have not backed up their parameters:drowning:
Cost a few minutes to back up to disk, untold grief when you don't!!
Al.

[confyone]

Hi,
The batteries died in our Fanuc O-M control wiping out all the parameters. The machine is an excel 810 VMC 1993. Does anyone have a the same year,make and model machine that we could get the parameters from?
Need help ASAP!!!!

Thanks,
Pete

HI
you have the parameters ?, I have a problem with the same CNC Excel 810 Control Fanuc O-M, when updating the parameters in specific when entering parameter 905 sheds ALARM SYSTEM 910 RAM PARITY LOW, does anyone know which RAM module you need to replace,


If you already have your Excel 810 parameters, you can give me a copy of parameter 900 to 921 please

[igorko100]

Hi All!

To Confyone:
Have you found a solution to this problem?
We have exactly the same - when we set parameter 905 the control does not start and shows error 910 PARITY (LOW)

I would highly appreciate any help.