Daewoo Puma 200S running a Fanuc 18-T, machine ran fine the night before and the next morning we get a 2010 alarm "Spindle Rotation Is Abnormal". Power it off and restart it doesn't help, the hydraulic pump will come on and run about 5 seconds then shuts off. Any suggestions? Thanks!
Results 1 to 3 of 3
-
09-17-2020, 02:29 PM #1
Registered
- Join Date
- Oct 2006
- Posts
- 15
Alarm 2010 Fanuc 18-T, Suggestions?
-
09-19-2020, 01:21 AM #2
Member
- Join Date
- Jul 2005
- Posts
- 380
Re: Alarm 2010 Fanuc 18-T, Suggestions?
Check incoming voltage. Also check for popped breakers.
-
09-19-2020, 09:58 AM #3
Member
- Join Date
- May 2016
- Posts
- 526
Re: Alarm 2010 Fanuc 18-T, Suggestions?
Check 24v supply if hydraulics shutting down possibly due to lack of signal that they are on.
The encoder requires 24v to activate as well
Reply With QuoteSimilar Threads
-
Fanuc & siemens 4th axis post processor for powermill 2010
By raju9095 in forum PowerMILLReplies: 1Last Post: 08-18-2020, 08:21 AM -
Spindle alarm 2010, Fanuc series O-M (Pictures attached)
By the_catalyst in forum FanucReplies: 5Last Post: 11-19-2017, 06:32 PM -
2010 doosan 2000sy fanuc 31i
By positiverake in forum Daewoo/DoosanReplies: 4Last Post: 02-14-2017, 10:43 PM -
Doosan 2000sy fanuc 31i (2010)
By positiverake in forum Daewoo/DoosanReplies: 10Last Post: 02-02-2017, 12:32 AM -
2010 Tool Not Available - Fanuc Om
By PPM in forum FanucReplies: 3Last Post: 08-24-2005, 09:22 PM
Tags for this Thread
Posting Permissions
