584,842 active members*
4,405 visitors online*
Register for free
Login
IndustryArena Forum > CNC Electronics > Spindles / VFD > Modifying recently purchased cnc and want to modify to control through UCCNC
Results 1 to 1 of 1

Hybrid View

  1. #1

    Modifying recently purchased cnc and want to modify to control through UCCNC

    Hello! I am getting back into routing and I am looking for a little guidance. I recently purchased a cnc router, that runs manually. However, I want to set it up that I can turn on the spindle via the software (UCCNC) and have the G-Code specify the RPM (Aspire). Here is the current setup and I am curious what I need.


    Software (UCCNC V1.2111)

    To Breakout Board (UC400ETH)

    Breakout board (ST-V3)

    X Stepper drive & Stepper Motor

    A Stepper Drive & Stepper Motor (X-Slave)

    Y Stepper Drive & Stepper Motor

    Z Stepper Drive & Stepper Motor

    Huanyang 220V 4.0KW FVD & Spindle (Not Sure which model)

    Now, the ST-V3 has a relay to control a vfd/spindle. However, as I am wiring it up, I believe I need a PWM board, but not sure how this is implemented in my current setup. I imagine it is controlled via my VFD and breakout board, where the breakout board will send the signal and the PWM board will continue that signal to the VFD. Any help on this is appreciated and please go slow. I'm still learning.
    Attached Thumbnails Attached Thumbnails 20201002_081446.jpg   20201002_081505.jpg   20201003_165717.jpg  

Similar Threads

  1. Recently Purchased Series II, can i run it with a VFD??
    By levig14 in forum Bridgeport / Hardinge Mills
    Replies: 62
    Last Post: 05-18-2017, 08:41 PM
  2. Recently purchased ArtCAM Express
    By artcamguru in forum ArtCam Pro
    Replies: 0
    Last Post: 11-26-2008, 04:28 PM
  3. Recently Purchased BTC 1 Boss 7.2
    By RobErnesti in forum Bridgeport / Hardinge Mills
    Replies: 3
    Last Post: 02-03-2007, 10:41 PM
  4. Recently purchased Hansvedt SE-180
    By lwhiway in forum Waterjet General Topics
    Replies: 0
    Last Post: 01-08-2007, 05:50 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •