[BKCOM]

Dear all.
I have CNC milling machine use FANUC Oi-M Controller.
i want to backup SRAM and load PMC LADDER file by FANUC LADDER III software .
Please show me to set the necessary parameters, i can not connect cnc with PC by FANUC LADDER III.
Best Regard !!!

[highspeedmike]

Power off machine then power on while holding down (right arrow key + the soft button to the left of it) These buttons are below the monitor. Doing this will boot CNC into a menu that will prompt you for different ways to backup pmc ladder, sram, parameters, etc. The easiest is to backup to a PCMCIA flash memory card, then use your software to edit.
Good luck!

[BKCOM]

Hi !
Thank you very much.
I have a 32Mb flash memory card when I backup it issue Message : SRAM PARITY OCCURRED PLEASE POWER OFF.
In I/O screen have not M-CARD title .
Regard.

[naeemmughal]

--------------------------------------------------------------------------------

Dear all.
I have CNC milling machine use FANUC Oi-M Controller.
i want to backup SRAM and load PMC LADDER file by FANUC LADDER III software .
Please show me to set the necessary parameters, i can not connect cnc with PC by FANUC LADDER III.
Best Regard !!!
[email protected]

[naeemmughal]

hello my name is naeem
pls some one help me i have a machining center
MONARCH VMC 75B
i lost my paramaters pls send me parameters
my e-mail id is
[email protected]
[email protected]