I have a Daewoo 6s lathe the battery died so I lost everything.

I do have a 14 page printout of settings to use. I have input lines 001 too 8000+ manualy typed in.

I have not had any luck in getting machine to go past start up info screen. I get no alarms up so can't really look up more info

There is a few pages with I think 9000+ number lines of code that I can't find where to input the data to..

From what I have been reading u can upload parameters from a pc I have old pc with rs232 port etc

Where do I go from here? Any help on where to input the last 6 pages of code in or a file I could try to load in would be very helpful and much appreciated

I did post a similar question in fanuc topic but I should have posted here sorry.