[jangermann]

Hi

I own a CNCEST 6040 and yesterday the spinnel stopped during a job with a error code E 0H (the controller got too hot).

Well I can deal with the error since I can mount a bigger fan in the VFD chassis, but the problem is that the spinnel stopped but ZXY was still moving.

I can see that there is a emergency stop input on the XYZ controller, but any one know if there is a Error/Alarm output from the VFD?

Thanks.

[mactec54]

Hi

I own a CNCEST 6040 and yesterday the spinnel stopped during a job with a error code E 0H (the controller got too hot).

Well I can deal with the error since I can mount a bigger fan in the VFD chassis, but the problem is that the spinnel stopped but ZXY was still moving.

I can see that there is a emergency stop input on the XYZ controller, but any one know if there is a Error/Alarm output from the VFD?

Thanks.

You would have to know what VFD Drive you have, these machines have come with many different VFD Drives