Hi there...I purchased this machine new in 1998 so needless to say I have had to reset the turret index in the past, and the protocol in the manual always gets it restored. This morning I was rotating the turret with a MDI command and before it reached its destination

there was a faint auditable click and it threw an alarm 79560 axis interlock. I manually went thru the drill of getting in position 1 and clamping it.(light went out) though the problem lies that the 3 button push to rest the tool # on the control it does not change....

I have a feeling that it must be the turret servo drive motor or the system that feeds power to it. The machine went obsolete a few years after I bought it and the manuals that came with it are a joke at best.. So my question is...has anyone shared this dilemma or have

a trajectory on how to trouble shoot where the problems lies? Any help would be greatly appreciated.