Hi Guys,

I am trying to run a test part with a drill followed by inside bore, the drill cycle gets the bit to the front face of the piece, then skips to the end of the cycle,
it then skips the boring cycle, and goes straight to the next cycle.

Anyone see what i'm doing wrong?#

(Okuma OSP U10L)

(DRILL3)
N103 M1
N104 T080808
N105 M8
N106 G94
N107 G97 S3000 M3 M42
N108 G0 X0. Z15.
N109 Z5.
N110 G83 X0. Z-38. R0. Q1. P300. F300. L38.
N111 Z15.
N112 G97 S3000 M3 M42
N114 M9
N115 X200.
N116 G0 Z200.

(PROFILE ROUGHING3)
N117 M1
N118 T060606
N119 M8
N120 G95
N121 G97 S3000 M3 M41
N122 G0 X0. Z5.
N123 G50 S3000
N124 G96 S200 M3 M41
N125 G0 Z-1.5
N126 X13.
N127 G85 NAT4 D1. U-0.2 W0.1 F0.5
NAT4 G81
N128 G0 X23. Z-1.5
N129 G1 Z-2.
N130 X22. Z-2.5
N131 Z-9.
N132 X14.
N133 G80
N134 G0 X0. Z-1.5
N135 Z5.
N137 G97 S3000 M3 M41
N138 M9
N139 X200.
N140 G0 Z200.