[Carter]

Could anyone please help me restore the parameters for the toolchanger on an ACE-V85 Fanuc 16-M? The operator was trying to recover from a magazine error and initialized the eprom.

[dhardt]

Did you loose the Fanuc parameters?
...the ATC (Vision or Promotion) parameters?
...the Magazine (Vision or Promotion) parameters?

What is the serial Number of the machine?

[Carter]

Ahhh Doosan... i called the Houston office yesterday around 3:30cst

ACE V85
AV850021
Fanuc 16M

i have lost the PMC Data TBL Control and the PMC PRM Data

[dhardt]

Do you have The Blue Book from the pocket of the electrical cabinet's door?
The values for your SPECIFIC machine are in that book. (If not, I'll try to get a generic copy for a V85 and we can figure out the differences...

[Carter]

we have a LARGE binder, from Daewoo with several books in it. The blue one is titled Parts List

[dhardt]

This "Blue Book" is similar to a rook report cover that a kid would use, with a cutout that allows the printed "model&serial#" to display from the printed page below (the pages are usually between 20-50 3-hole-punched)...it is usually located in a pocket in the electrical cabinet's door.

Is there one there?

[Carter]

no, the only thing in there was the binder with operator manual, parts list, ladder and electrical books inside.

[dhardt]

I've contacted a customer with a V65 and 16M control, whom I've been helping this week. He says that his Blue Book has V85 choices, also. He's scanning it to send it to me. Email me at [email protected] so I can forward it on, to you.

[Carter]

email sent. Thank you, Sir!

[jholapara]

email sent. Thank you, Sir!

Dear sir we have same machine and face same problem lost pmc parameters so can you help us.

My mailid is [email protected]

[dhardt]

Dear sir we have same machine and face same problem lost pmc parameters so can you help us.

My mailid is [email protected]

What is the Serial number?