Re: What BT30 pull studs does a DM2800 use?
Recommended torque on the pull studs is 25 to 35 ft/lbs. I use the lower number.
I also put anti seize on the threads and face. Makes it real easy for switching them out later.
I haven't counted lately but my tool cabinet has over 250 tool holders in it.
At least 50 are dedicated to drill and another 50 to end mills.
If my program calls for any common drill, I just grab it off the shelf, enter the offset and away it goes.
I can switch up tooling and programs in less than ten minutes.
Timothy
Dyna Mechtronics DM4400, Bridgeport Discovery 300, HAAS VF-0E, HAAS VF-2D
BobCad 16, 20, 24 and now V25