[REGGIE1010]

hi all
i work in a kitchen company and we've just started using the 12mm to 20mm thick concrete worktops (compressed paper i think) what i'm trying to do is create a panel for a kidney shaped sink cut out approx size 500mm - 400mm and then save it so i can import it on to a different panel say 600mm - 2400mm in a set position

any help would be appreciated

mark

[murda]

Hi Mark, you can save that program with cut as subprogram (into folder p_p/sprog/) and call it from any program by instruction L=subprogram_name .

[Jack8]

You could also create the machining as a macro and then it'll be saved into it's own little tab on the right hand side under the Macros. Then it'll be a case of changing the variables.

[murda]

Yes, thats possibility if you have Biesse works editor.