[MetalDawg]

I have a new 2020 Lynx 2100 LSYB that has the new Oi-TF Plus control.

Does anyone have instructions on how to calibrate the tool setter? I would call Ellison, but it is the day before thanksgiving and no one is answering the phone.

There is a ten year old thread on this subject that talks about what numbers go in which parameters, but I am not confident those parameter addresses are the same for this new control.

Thank You!

[dhardt]

I just called and they picked up on 2 rings...

Unless Fanuc has changed their parameter, or the write-up is not for a Fanuc, it will work.

Your instruction Manual that came with the machine has replacement process, as well.

The attached is the Installation Manual for a Lynx 220. The process is on page 28

[MetalDawg]

Thank you very much for the reply. About 30 minutes after I made the post I made another call, and they did answer. They put in a case number for someone to get back with me. I might have called too early since I called right at 8:30am local. I looked in the instruction manual, but I did not see it. I will look again though. I really appreciate your help.

Thank You!
Darryl