Originally Posted by
Cfin
That part went fine ... it was sitting very close anyway, from memory 0.1V .... but adjusted to 0v with a minute change.
Been fiddling again ... and I notice that if rpm's are at 199rpm or less, the spindle will actually stop when its told to ..... 200rpm or more and it won't ?? When doing the DI/DS check, you could only see the change in switch state when moving the spindle slowly by hand. I put this down to perhaps the screen display updating was too slow to actually "see" the change and it changed back to open state ? Magnet strength is reasonable but maybe the hall effect is weak ??