584,837 active members*
5,674 visitors online*
Register for free
Login
IndustryArena Forum > CNC Electronics > DeskCNC Controller Board > Anyone have a Deskcnc controller lying around they might sell me?
Results 1 to 3 of 3
  1. #1
    Join Date
    Oct 2019
    Posts
    6

    Anyone have a Deskcnc controller lying around they might sell me?

    Its my last option before just giving up on the system, the z-axis keeps trying to go way to fast and causing all the server drivers to shut off. My x/y axis are working fine, this about only hope to save the system, cause fred want $350 for a new one and for that I could pretty much just replace the hole system. Already check every wire about 100 times over. Maybe just get a cheap server job and mach3. Deskcnc really isnt the best out there

    So you got a system your ready to brick, let me know.

    Thx

  2. #2
    Join Date
    Apr 2007
    Posts
    60

    Re: Anyone have a Deskcnc controller lying around they might sell me?

    Sure, I have 3 DeskCNC cards, plus a PWM to 0-10V spindle VFD driver card.

  3. #3
    Join Date
    Oct 2019
    Posts
    6

    Re: Anyone have a Deskcnc controller lying around they might sell me?

    Hi, how much do you want for one of the controller Cards For desk CNC. I think I have a bad one. Also will the PWM to 0-10V spindle VFD driver card work with a Sherline mill, if so how much for both. PM me or send me an email at [email protected]

    Thanks

Similar Threads

  1. DeskCNC to HAAS controller
    By Stratotanker in forum CNC (Mill / Lathe) Control Software (NC)
    Replies: 1
    Last Post: 06-23-2011, 11:46 AM
  2. DeskCNC to HAAS controller
    By Stratotanker in forum Haas Lathes
    Replies: 0
    Last Post: 01-23-2009, 11:16 AM
  3. Replies: 11
    Last Post: 08-06-2007, 01:25 PM
  4. DeskCNC 2nd. gen controller AND HobbyCNC Pro Controller
    By maycom in forum DeskCNC Controller Board
    Replies: 1
    Last Post: 06-02-2007, 07:33 PM
  5. DeskCNC Controller/driver
    By rogerbureau in forum DeskCNC Controller Board
    Replies: 0
    Last Post: 01-18-2005, 09:30 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •