Looking for help on this machine no idea where to begin or how much to get it running. Want to use it to cut up to 1 inch steel . Would also like to convert to plasma.
Looking for help on this machine no idea where to begin or how much to get it running. Want to use it to cut up to 1 inch steel . Would also like to convert to plasma.
That's an oldie.
To begin:
Look at the overall mechanical condition, determine what needs maintenance and repairs
Anchor the machine to the floor, level and square.
Take an inventory of the existing axis motors and drives.
Look at the existing controls and see what can be reused.
Remove all of the gas torch hardware
Buy a Hypertherm Powermax 105 or equivalent
Buy a new control system, many vendors are available, from really cheap to crazy expensive.
Looks like you have a project there. Pretty easy to get it going if it's mechanically OK.
Jim Dawson
Sandy, Oregon, USA
Looks a little Like an old (Linde) trace cutting M/C I once did, converted using Galil motion Card.
Al.
CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
Center cut is a hypertherm company give them a call