Question. What are the control circuit connectors used on these VFD's called? I think the pin spacing is 2.4 or 2.54 mm. I bought this VFD from Surplus Center and it came without the screw terminal connectors.
Results 1 to 2 of 2
-
06-17-2021, 11:13 PM #1
Registered
- Join Date
- May 2018
- Posts
- 3
FUJI FRN0.75C1S-7QI 240 VAC 1PH to 3PH VFD
-
07-08-2021, 12:10 AM #2
Registered
- Join Date
- May 2018
- Posts
- 3
Re: FUJI FRN0.75C1S-7QI 240 VAC 1PH to 3PH VFD
Could not get much info from Surplus Center. I finally found someone at FUJI that told me that these VFDs were programed for a specific machine and were not able to be used otherwise. All I could get it to do was power up, but could not change any settings and could not get power out to the motor. Sent them back and got a refund.
Reply With QuoteSimilar Threads
-
Mach3 PWM Spindle Speed Control using 220v 1ph VFD/220v 3ph spindle motor.
By Ozzwinkle in forum Mach Software (ArtSoft software)Replies: 4Last Post: 12-23-2013, 07:01 PM -
Can a 3ph input VFD Hitachi J100 run on 1ph ?
By maquiza in forum Phase ConvertersReplies: 9Last Post: 05-26-2009, 04:55 PM -
running a 1PH motor on a 3PH converter
By bmachinist in forum Phase ConvertersReplies: 3Last Post: 11-27-2007, 03:07 AM -
3ph to 1ph help
By actionman in forum Welding Brazing Soldering SealingReplies: 6Last Post: 04-14-2007, 10:30 PM -
Can a 3ph input VFD run on 1ph ?
By Don Lester in forum Phase ConvertersReplies: 3Last Post: 06-27-2006, 06:51 PM
Tags for this Thread
Posting Permissions
