I have been in the process of rebuilding my CNC router machine. I am now get it rewired. When I shut it down everything was working properly.
The controller is:
UC300ETH-5lpt
Uccnc software.
The problem is that when I power the system on I get nothing out of the UC300 -- no led at all. I have verified there is 5 volts at the board plug in and that the jumper is set for ext 5 volt. From the CNCDrive forum I was told that it means it is not getting the 5 volts.
I need to determine if the problem is the 5lpt motherboard or the controller board. So I am looking for the pin out of the UC300 controller board. I would like to know where to hook up the 5volts directly to the UC300 (rather than via the 5lpt) to see if it will light up.
Thanks for any help.
Sam