Hi
I recently bought 2 Powace 6040z machines and I can't get them to move. For troubleshooting I have been able to try software on both of them.
Been looking around on this forum and the only other post I could find with the same machine, or at least USB motion controller card as mine, have had no replies.

I have tried with the drivers and Mach3 software send over by the seller after contacting them. I have also tried a bunch of other drivers suggested in threads here without any success as well.

Been trying it on a Windows 10 64 bit, and a clean install of Windows 7 32 bit. The screenshots attached are from the Win7 install.

I get the error message in Mach3 of "No UsbMachBoard, please plug it in!"

I hope someone can help me out to identify the USB controller board or the right drivers to use, or anything really.
Thanks.