So I ordered this set-up from Amazon.ca. Came in looked good. Finally over the Christmas break I hooked it up on my CamTech CNC router. I replaced a Freud2000 3.25hp plunge router. Now the test. I put in my 2" flattening bit into the ER20 collet and clamped down a piece of hard maple. I wanted to take a full 2" wide cut at 0.1" deep. Hand jogged into the wood at about 60ipm. The spindle just stalled. I know my Freud router would have done the cut. So did I just buy a weak spindle? Let me know what you guys think.

Thanks

Kevin