[FADALDMU50]

Hi Guys .
Im stuck on the X axis and looking for help on getting the axis back to normal.
I did make sure the stroke is back at the factory setting to save my tail.
My problem is whats what here .
Is it a press switch or a toggle switch that needs to be activated.
Here is what I have found in my manual and a picture inside the cabinet

Please advise the proper way to get the machine off the alarm

And Happy New Year

[FADALDMU50]

OK
So I got the machine to move, but its not moving the correct way,.
My Factory stroke Settings are
P 365.2417
N 351.4622

What do I need to open them up to make this work and also why is it not moving in both negative and Positive directions ??
Its moving out and I want top move in...

[Algirdas]

Technically it is not complicated. More details and specific would help a lot.
1. What happens between time point "machine is working correct" and time point "today" ? Some maintenance/ lack of maintenance ( dirt collected ) ?
2. What is status of hardware limit switches.
3. The tumbler "Stroke End Cancel" must be back to 0 ( off status ) when the axis moved away from the limit point.
4. Look if axis moved to parameter stroke limit doesn't touch the hardware limit switch.