Originally Posted by
boydage
Hey so this is a good representation of what I am doing presently. I actually didnt end up using this operation as the first time I tried it, the facing op went well, then the first tool change was fine until the second part that I stopped it from crashing.
As mentioned I am going to install the macros that Gerry has posted and look forward to trying this type of operation out. I do have a smart vice where I can just set all the parts up on that to a maximum of 4pcs but do really like using multiple WCS(s). I have just arrived home to a consignment that's arrived with some parts. I am replacing the ball-screws on my gantry from 16mm to 25mm. And have built a serious and way over the top series of gussets to strengthen strengthen strengthen.
Anyways. Attached is the code where it all went wrong. I ended up machining these parts with one wcs in the middle. Hey so I tried uploading the NC file and am unable too. And the code is too long to paste here. I have pasted it into a word doc - how else would I do it, seems incorrect. Darn it wont let me upload a word docx or now it says too large. I have zipped it up let me know if it comes through - lots of code in there. Regards B