547,379 active members*
2,468 visitors online*
Register for free
Login
IndustryArena Forum > CNC Electronics > General CNC Machine Related Electronics > Stepper Motor making noise but not moving
Results 1 to 1 of 1
  1. #1
    Member
    Join Date
    Jan 2021
    Posts
    1

    Question Stepper Motor making noise but not moving

    Need Help !!!

    I have an Alpha 42hs60-15a4 motor and it is connected to a4988 driver, it set to 0.6 current limit, connected to 15v 10 amp power supply, A CNC shield used to control the motors and i already uploaded grbl on an arduino uno and start using universal gcode sender to control of the axes associated with motors, But when sending a signal from the gcode sender software motors start making noise instead of spinning.

    i have already weird it as it should bd and i have tested 2 cnc shield on the same circut
    Attached Thumbnails Attached Thumbnails 137041093_136538354834278_4054381948148345058_n.jpg   136939166_156495746251308_6886104755064038890_n.jpg  

  2. #2
    Registered
    Join Date
    Dec 2012
    Posts
    188

    Re: Stepper Motor making noise but not moving

    start at a very low speed. You might overrun the motor starting speed. then you will only hear the noise and the motor is only vibrating

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •