Hi everybody
Our LU 15M machine is running from disket driver but MB 56 machine doesn't run from floppy diskett driver.
?t gives 5261 error
Hi everybody
Our LU 15M machine is running from disket driver but MB 56 machine doesn't run from floppy diskett driver.
?t gives 5261 error
What is your point? You want to transfer part program from the lathe to MC ?
In my understanding both LU15M and MB56 should run even with floppy drive detached, but most likely it is not your question here.
I mean program select and cycle start
clear. First of all, do you see ( on OSP ) the contents of the floppy?
Is the floppy Okuma OSP format or MS-DOS format?
Yes I see inside of floppy. It is OSP format.
..720 or 1.44 format
5,25 disk?
1.44 format copying ok but program select no it is option or parametric ?