I have a CNCRouterparts PRO 4"x8" from 2014. It has been unused for a few years, and when I wanted to start using it again my PC was broken so I do not have the original MACH3 settings.

I then upgraded to UCCNC software and AXBB-E motion controller. I've got it all running but I can’t figure out how to calculate my stepper motors. And right now my brain is burning from messing with it all day.

I found this calculation from cncrouter parts https://www.avidcnc.com/pro-rack-and...-34-p-226.html I hope it is the same specifications on the 2014 model. and I have a DQ860MA drive which is currently set to 1600 micro steps. But I do not mind if it is changed.
in fact I would greatly appreciate if you have any suggestions for the best settings!

Could someone please help me figure out what to write in UCCNC to get it up and running?

Also I am from Denmark so I do everything in mm not in inches.