[mactec54]

According to my book:

PD175 = Inverter model
PD176 = Can be set to 0-50Hz or 1-60Hz Factory is 0
PD120 = Stall Prevention - 0-200% Factory is 0
PD010 = Min Starting Voltage Factory is 8 for 220v class

I have not changed any of these (including the 06,09,07,10

I should be safe leaving them at Factory, except for PD120. If left at 0 that would disable stall protection. So that I would change to 100.

Does that sound workable?

Some of the different models has some slight differences in there manuals

Correct PD120=100

Factory Defaults are for a 50Hz or 60Hz Ac motors, they do still work but are not what your 400Hz spindle should have

[SamHam]

I cant find anything more than this on the spindle.

Voltage 220
Current 10amp
Phase 3
Frequency 0-400Hz
Speed 0-24000rpm
Collet ER20
Bearing Ceramic

Where / what more should I be looking for?

[mactec54]

I cant find anything more than this on the spindle.

Voltage 220
Current 10amp
Phase 3
Frequency 0-400Hz
Speed 0-24000rpm
Collet ER20
Bearing Ceramic

Where / what more should I be looking for?

I guess it is 2.2Kw or is it 3Kw

[SamHam]

2.2Kw

[SamHam]

Mactec54,

Any more thought on what

PD006=
PD009=

PD007=
PD010=

should be for a 2.2 air cooled spindle?

[mactec54]

Mactec54,

Any more thought on what

PD006=
PD009=

PD007=
PD010=

should be for a 2.2 air cooled spindle?

Sorry I did not think you where up and running again, I will do some, air cooled what was there recommended minimum speed this is important

[SamHam]

They did not have a recommended min speed. I currently have it set to 6000 (100Hz)

[mactec54]

They did not have a recommended min speed. I currently have it set to 6000 (100Hz)

That is normally to slow for air cooled spindle so you will have to try it and see if it over heats at that speed some have to be as high as 150Hz to keep them cool enough it will depend how efferent the fan is at low speeds

[SamHam]

Even though I have run it at 6000 for up to 30 minutes without it getting warm (just breaking it in), I don't really need that low a speed except for occasional drilling. I could adjust my settings to 120Hz (7200) easy enough.

[SamHam]

I've changed my VFD to 120 for minimum speed. Any more input for
PD006=
PD009=

PD007=
PD010=

Now?