[DavidR8]

Hi, I'm just getting my feet wet with Fusion 360 and GRBL as I build my CNC plasma table.
I drew up a simple shape and did the CAM work in Fusion360. I picked the stock plasma cutter in Fusion360 and the simulation worked fine.
When I went to post process the CAM into the GRBL post processor, I got an error saying "The CNC doesn't support the required tool/process. Only laser cutting is supported"
I switched the tool to the laser cutter, re-checked everything and t seemed fine but still wouldn't post process.
I checked the autodesk CAM updates and it's the most current version of GRBL.
I'm a bit stumped about what's wrong.
I hope that I can get a bit of guidance here...
(if I'm in the wrong sub-forum my apologies)

[hfjbuis]

I think you should post your question in a fusion 360 related (sub) forum.
https://www.cnczone.com/forums/autodesk-cam/

[DavidR8]

Thanks @hfjbuis. I wasn't sure if it was a F360 problem or a GRBL problem.