Re: I need help, Viper 200 can not save the paramters
Originally Posted by
trikepedaler
Today I was able to save the settings. It was one of the jumper i misplaced. Got the servo to run up to about 2100 rpm before the drive faulted with encoder fault.
Frank
It could be hitting the top of the PS region where its hard for the pid for control the motor. I had sent some out with a PWM clip setting that was off .It should be set to 1700 on V200H
Larry K
Manufacturer of CNC routers and Viper Servo Drives
www.LarkenCNC.com and www.Viperservo.com